>
> > Hey Paul! Do you remember Joe Schiferl's velocity and how
loud it
> was when
> > it left
> > Oshkosh? Proving that you can kill people with sound good lord
> that was
> > loud. Even
> > when he was outta sight. I could clearly hear his
airplane. Anyway
> I
> > thought that the
> > concept for cooling was interesting. but I was wondering
if the
> shroud
> > that he had
> > behind his airplane where the exhaust exited out the back
there!
> I was
> > wondering if
> > that whole thing couldn't be turned into some kind of
muffler to
> get the
> > D.B's down a
> > bit. Here is the drawing of what I think it may look like.
> > may work on my Long ez.
> >
> > Tony
> >
> > No muffler. Just an augmenter. You can hear all rotaries miles
> > away as they have a unique sound.
> >
> > Paul Lamar
>
> I'm working at fabricating an augmenter [Ejector] similar to what
> Tony sketched out
> (see attached jpg). I am considering placing some mineral
wool or
> other
> sound deadning material in the augmenter side walls. The
> exhaust/cooling
> air temperatures should be considerably less than a conventional
> muffler and
> the air stream velocities should also be reduced which gives the
> 'glass
> pack' a much better chance of serviving.
> D Johnson
>
> Good idea. Easy to do. Might work well.
> However that was a blank jpg file you attached.
>
> Paul Lamar
>
> I think that's a good idea. I did it quite a few years ago to the
open
> exhaust on my VW gyro, I called it a "halo", It consisted of a very
> light aluminium tube about 9" diameter about 2' long open at both
ends
> and lined with rock wool. It certainly took the edge off the exhaust
> note. It would probably work well on the high frequency stuff from a
> rotary. I think I had the exhaust pipe terminating about 3" into the
> halo.Air entering the front kept it all cool.
>
> John Evans
>
It is interesting that you used aluminum. I was wondering if the
temperatures would get low enough in the muffler/augmentor to use
aluminum.
I would have to look up the article in Contact magazine where the
author did
static testing of an augmentor and said that the augmentor was warm
to the
touch but did not was not hot enough to burn. I will probably build the
prototype out of galvanized sheet metal for static testing. I
suspect that
the mouth of the augmentor would have to be stainless steel because the
exhaust & cooliing air is not well mixed. If the temperatures are low
enough for aluminum would there be other concerns such as corrosion
form the
exhaust gas residual?
D Johnson
I may have been a little misleading in that my "halo" was purely
designed to act as a "sound deadener", rather than an augmenter [ejector], with
plenty of fresh air entering the front, it never got hot.
John Evans
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.