Subject: Thank God for the Mazda rotary engine.
From: Rotary Engine
Date: 8/18/2005, 6:01 PM
To: AA-me


Paul

Does the rotary do well lean side of peak ? I imagine it would with state of the art electronic ignition and manifold pressure inputs.

bill

From: Rotary Engine <rotaryeng@earthlink.net>
Date: 2005/08/18 Thu PM 04:07:27 PDT
To: AA-me <rotaryeng@earthlink.net>
Subject: Thank God for the Mazda rotary engine.

This is from Flying magazine September 2005 page 46 about the Lancair
Columbia powered with a state of the art Continental TSIO 550-C 310 HP dual
turbo, dual inter cooler, air cooled aircraft engine. Aircraft price $536,000.

"There is a 10-gallon fuel imbalance limitation in the 400, so the tanks have to be switched frequently in a full-power climb where the fuel flow red line is at 40 gallons per hour. We climbed to 17,500 feet, using nasal oxygen cannulas to sustain life, where at maximum cruise power, as set by Doug, the true airspeed as calculated by the Avidyne system settled on 225 knots. The fuel flow was 22.5 gallons per hour, which was somewhat below the book figure of 25 gph shown for max cruise. Still, using the .45 pounds per hour per horsepower specific fuel consumption that usually works for turbocharged pistons, the fuel flow experienced suggests that we were developing 300 horsepower, which is a fairly high percentage of the 310 rating for the engine. It is quite obvious that the engine makes more power than the rating.

Here we must become controversial. Doug leaned the mixture to 50°F on the lean side of peak. The airspeed dropped by seven or eight knots and the fuel flow was reduced by maybe four gallons per hour. Doesn't that sound like magic? Trouble was, the engine, which wasn't all that smooth in this airplane to begin with, became decidedly uncomfortable. Doug even said that when running lean of peak the engine would occasionally stumble or splutter.

Even without the stumble or splutter I was uncomfortable with the engine's apparent discomfort when running lean of peak. From a technical standpoint it might be okay to run like this, but there is no way I am going to fly an airplane with the engine running in a ragged manner. I'd rather buy the gas to make it go as
  fast as possible and run as smoothly as possible and leave the alleged magic to someone else.

Additionally, the POH specifies that the engine be run at best power mixture when operated between 65 and 85 percent power. That is all the more reason. to burn the gas."

Sooner or later you will be flying a rotary.

Paul Lamar

Paul

Does the rotary do well lean side of peak ? I imagine it would with state of the art electronic ignition and manifold pressure inputs.

bill

It runs smoothly up to 200 F lean of peak and then it just quits if leaned
further.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.