Subject: Thank God for the Mazda rotary engine.
From: Rotary Engine
Date: 8/18/2005, 6:04 PM
To: AA-me



This is from Flying magazine September 2005 page 46 about the Lancair
Columbia powered with a state of the art Continental TSIO 550-C 310 HP
dual turbo, dual inter cooler, air cooled aircraft engine. Aircraft
price $536,000.

"There is a 10-gallon fuel imbalance limitation in the 400, so the tanks
have to be  switched frequently in a full-power climb where the fuel
flow red line is at 40  gallons per hour. We climbed to 17,500 feet,
using nasal oxygen cannulas to sustain  life, where at maximum cruise
power, as set by Doug, the true airspeed as calculated  by the Avidyne
system settled on 225 knots. The fuel flow was 22.5 gallons per hour,
which was somewhat below the book figure of 25 gph shown for max cruise.
Still, using  the .45 pounds per hour per horsepower specific fuel
consumption that usually works  for turbocharged pistons, the fuel flow
experienced suggests that we were developing  300 horsepower, which is a
fairly high percentage of the 310 rating for the engine.  It is quite
obvious that the engine makes more power than the rating.

Here we must become controversial. Doug leaned the mixture to 50°F on
the lean side  of peak. The airspeed dropped by seven or eight knots and
the fuel flow was reduced  by maybe four gallons per hour. Doesn't that
sound like magic? Trouble was, the  engine, which wasn't all that smooth
in this airplane to begin with, became decidedly  uncomfortable. Doug
even said that when running lean of peak the engine would  occasionally
stumble or splutter.

Even without the stumble or splutter I was uncomfortable with the
engine's apparent  discomfort when running lean of peak. From a
technical standpoint it might be okay to  run like this, but there is no
way I am going to fly an airplane with the engine  running in a ragged
manner. I'd rather buy the gas to make it go as
  fast as possible and run as smoothly as possible and leave the alleged
magic to
someone else.

Additionally, the POH specifies that the engine be run at best power
mixture when  operated between 65 and 85 percent power. That is all the
more reason. to burn the gas."

Sooner or later you will be flying a rotary.

Paul Lamar


Some of this is just silly, however.  Those engines don't run LOP very
well unless they have matched injectors - can't imagine why TCM doesn't
build them that way to start with.  Even if you don't run LOP, matched
injectors make the engine easier to fly.

Anyway, to run lean enough to keep the cylinders cool, 65% power is about
all you can make.  Any closer to peak EGT, and you get more than 65%
power, and you run too hot.  No great mystery.

I bet John Deakin is fired up about this article - or maybe not since this
topic is still so misunderstood...

Even so, I agree, rotaries make much more sense.

Matt-

I went throught the Continental factory tour when I picked up my new O-470
and they claimed they were matching the injectors.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.