Paul Lamar wrote:
The big problem with it is pilot error. If you screw up
and open the throttle or descend without changing or reseting the
mixture you could damage the engine exhaust valves and cylinder heads
as the EGT's go to or through peak.
Uh, if you open the throttle or descend with the engine running LOP, it
will die. This is because adding air (either through opening the
throttle or increasing the air density by descending) makes the mixture
*leaner*.
I think that is why Lycoming will not honor the warrantee if you
run lean of peak. Strictly prohibited.
Only Lycoming can say for certain why, but my guess is because running
an engine LOP
*correctly* requires matched fuel flows per cylinder.
Without matched fuel flows (i.e. in "factory" condition), attempting to
run LOP may cause one or more cylinders to run at peak EGT, which tends
to foreshorten those cylinder's lives.
Russell Kent
Yep! I always get that wrong.
Scenario #1... throttle wide open
over 8000 feet... climb less air... mixture starting lean LOP...
going richer... towards peek EGT.
Scenario #2... throttle less than wide open
less than 8000 feet... mixture starting lean LOP... open throttle
more air.... going leaner ... engine dies.
I have a EGT/CHT 6 cyl scanner and I can run 50 F lean of peak on worst cylinder.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.