Has anyone installed the [RX8] eccentric shaft position sensor on a 13B?
Are any modifications required to install the steel plate?  Does a
special bracket for the position sensor have to be built or can the
Renesis bracket be used?   Does this work with an  EC2 that was
intended to be  used with the CAS?    Jerry

I suspect a special bracket would be needed.
Also the third gen had a similar system with two pickups and that works
with Tracy's computer. I am not sure Tracy has adopted the
RX8 version but I suspect he has as he is running an RX8 engine
as we speak.

next message -----------------------

Here is what the third gen trigger plate looks like. The single
small protrusion on the right probably gives the computer the TDC position
of rotor one using one of the two mag pickups.

This would be a similar situation to my photo electric flex plate
arrangement with the dual photo interrupter system.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.