> Paul, what was the dimensions of the TES [rotor] O rings you sent me?
I
> think
you got them from Creavey? I am building another engine (for a car)
and
I would like to order some more of them. They are still working great
in
the RV-6
Chuck Dunlap
I assume Chuck you are talking about the oil seal O-rings
on the sides of the rotors.
old message.
-------------------------------------------------------
I checked the installation of the oil O-rings with the new
sizes I got from Creavey. They worked perfectly and were
very easy to install. You will need a little O-ring lube
and a 2 by 8 to install them. They were also easy to remove
with no signs of distortion.
One of the secrets is if you reuse the old oil scraper rings
they must be spotlessly clean inside and out. Soak them
in carb cleaner for a few days. If you use new scraper rings
this will not be a problem of course.
The second thing to watch out for is don't nick the
rotor wall between the two scraper rings when you remove them.
Very very important!!
The proper sizes are:
0.093" section 4.68 inch ID
0.118" section 4.33 inch ID
I can vouch for the quality of the Creavey O-rings but some
of those water TES o-rings from Mcmaster Carr I have seen
are not as good. This is not to say they won't work. They just
don't look as good around the joints as Creavey O-rings.
----------------------------------------------
Paul Lamar
Chuck,
One of the other builders sent a housing to Creavey to check sizes, if
we
are indeed talking the larger "O" rings.
Just ask them for the Mazda Housing ones.
George ( down under)
These are the oil O-rings George. Not the water O-rings. Sending
an old rotor as well to Jeff Chrysler at Creavey along with a set of
the oil scraper rings would be a good Idea. He could clean them
up and use pictures of them on his web site or for advertising.
Paul Lamar
Hello,
The dimensions and pricing for the 4 sizes are as follows:
.093 x 11.190 ID $8.33 each 3 min
.093 x 8.950 ID $6.60 each 4 min
.093 x 4.680 ID $4.59 each 6 min
.118 x 4.330 ID $4.47 each 6 min
Thank you,
Jeff Chrysler
Thank you Jeff. Your O-rings are wonderful. We have accumulated hundreds
of hours in heavy duty rotary engine service with no problems.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.