Matt

Yup... you are right.   I am also curious if the sensor can be just a
pin and a concentric ring around a pin encased in plastic and installed
through the spar in several locations.

What is the output signal from the sensor?  A resistance value or a
simple gate? I would like to assign a value to each of the sensors and
interface it to the digital or analog gauges. It would be rather simple
to make a resistance value for each sensor chip output if analog.



Doug in Japan

-----------------------------
YIKES!!
I would be very reluctant to install something "through the spar". You
could be jepordizing the strength of the spar.
Bill Schertz
KIS Cruiser # 4045

Through the spar cap would be bad.  Analysis might show that holes in the
shear web would be of no consequence.


Matt-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.