Subject: New intake manifold design.
From: Rotary Engine
Date: 9/9/2005, 11:11 AM
To: AA-me

This is mainly for automotive rotary applications as aircraft
engines do not need torque down low. The Rx8 engine has a very complicated
and bulky system designed to generate torque from very low
RPM. This system is designed to replace that. It is more compact,
simpler and gives a lower overall height for the engine package.

The plenum sleeve inside not only rotates but it translates along the
engine axis. That means the runners can be helices with two or more
360 degree turns. The length of the runners then can vary between about
10 inches long to over 30 inches long. This system is very similar to what
Mercedes and BMW uses on their V engines but the range of runner
length accommodated is much shorter on those engines. This is fine for a V8
that has a limited RPM range but not so hot for a rotary
that revs to 9000 RPM.

A four port version is shown but a six port is also possible.
The runner connections between the ports and the helices are not yet
shown in these 3D's.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.