Subject: Optimal GPM water pump flow.
This may have inadequate variables, but looking for optimum Gallons Per
Minute desired water pump flow for a 13B 2nd gen, at 6000 rpm but
boosted to 250 hp max (realistic is 200-225, but I dont want to
marginalize capacity). Assuming no more than 20 psi and no undue flow
restrictions.
Any takers on the math?
Why: spec'ing a racemate direct drive water pump and alternator.. I
intend to order in the next week and want to select the right one.. or
the "most right" one.
Dave
I can give you a guess. Unless it is 30 or 40 gallons per minute forget it.
The flow will depend somewhat on the heat exchanger you plan on using.
Two pass is slightly higher resistance than single pass.
Really nobody really knows as nobody other than Mazda has installed a true
metal temperature gage as far as I know. The metal temperature around
the lower spark plug near the combustion chamber is the bottom line.
The water temperature is only distantly related.
Paul Lamar
------------
Without further info I can suggest that the optimum for overall system
design is going to be with a loop delta-T in the range of 20-30 F. So at
225 hp is going to require 27 - 35 gpm for pure water, and about 37 - 50 gpm
with 50/50 water/glycol mix. Of course it is difficult to detmine 'optimum'
heat exchanger design to go with it. Lower flow/higher delta-T needs more
exchanger area, which is determined by airflow requirements. Steady 225 hp
will need something around 6000 cfm air flow on a 90F day.
I measured pretty close to 50 gpm @ 6000 rpm on the dyno with no thermostat
and unknown cooling loop pressure drop.
FWIW,
Al Gietzen
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.