Hi Paul,
What rotor housing would you recommend for the P Port? If one were
to
purchase new rotor housings which type? Turbo N/A? I would like to use
the
E shaft and rotors from my 89. Is there a different criteria for using
old
housings for the P Port? How much travel is there in the slide throttle
set
up? Would like to know as I am fabricating the throttle quadrant. Thanks
Joe Berki
Limo EZ
I am not sure about this but I think Dave Lemon owner of MazdaTrix told
me all new replacement p-exhaust-port rotor housings are the same.
For awhile there 3rd gen were different than 2nd gen. And turbo 2nd gen
were different than non turbo 2nd gen. Turbo rotor housing had a bit
of web machined away around the lower spark plug to improve the
metal cooling in that area. Kind of a kludge until they could change
the die casting molds. The rib machined away was right where you see
the black line for the thermal couple. Of course the small hole for the
thermal couple should be in the center of the rotor housing directly
below the spark plug.
From the looks of the RX8 rotor housings the castings may also be what is
used
for 2nd and 3rd gen replacement p-exhaust-port rotor housings. They may
just
be machined differently at the factory. IMHO the exhaust port may just be
merely
machined out. On second thought the RX8 uses different oil injector
locations
so this may not be possible.
Best to ask Mazdatrix this question.
The slide throttle must move 1 and 7/8 of an inch to open and close the
port completely.
Paul Lamar
Joe,
The housings I'm using is the Cosmo housings which have ( I'm told) the
biggest exhaust port other than Turbo ports.
On checking I found the turbo ports have greater overlap than my Cosmo
housings.As we know any additional overlap will cause more problems with
idle, so the Turbo housing are out for my application.
However my Cosmo housings have the oil ring grooves in the Rotor housings
and therefore may not be suitable for your application but are perfect for
my single rotor development, as I'm using 12A end housings.
This info may give you some things to look for.
George ( down under)
Don't you mean the water o-ring grooves George?
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.