Subject: Slide Throttle Rev 11 Spacer .375"
From: Rotary Engine
Date: 9/14/2005, 11:57 AM
To: AA-me


Paul, see attached pic,  I've created the .375" spacer.  I'm getting pretty good at making these by hand.  With such low production numbers I may just do that if this design works out.  I'll ship this off to you today if thats ok.  T.W.

Looks good Tom. I need it for Marks manifold. I'll have the 3/8 Teflon
tommorrow morning. The buttons should be in today anytime now. If you need
one or two let me know. I am getting ten.

Are you still using the plasma cutter?

I was thinking a water jet might be better for this thick material.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.