Paul,  I have the photos of your alternator bracket.  Any chance
there is a measured drawing?   Jerry

Not much of one. If you are not using the crank angle sensor
the dimensions are not critical. I made mine out of a chunk of angle
iron. Don't make them out of aluminum. Aluminum alternator brackets
are infamous for cracking for some strange reason. 4130 is the best.

Here is the drawing.
http://www.rotaryeng.net/alternat.gif
And a picture.
http://www.rotaryeng.net/assembled-alt.jpg

Not guaranteed to fit your alternator. You will have to build a prototype.

Paul Lamar

Jerry, have you considered what Bill Schertz did with his alternator
bracket and rear motor mount combined?  Will work with our latest
scheme for the rear motor mount using the 1/2 inch rubber rod end.
Kills two birds with one bracket.

Paul Lamar


The  Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.