That is a good question. Chapters have been written on the subject. I
suspect there is no direct analogy with a piston engine because
of the moving combustion chamber. Here is some stuff from Yamamoto. Also
a drawing of an old idea I had. Won't work as it will suck
HP to compress the air required. Unless of course the air compressor is
run off the waste exhaust energy alone.
Paul Lamar
---------------------------------------
After thinking about it some more my air injection idea above
won't work as combustion pressure will leak above the apex seal across
the air injection hole. It is going to take some real ingenuity to
get stratified charge to work on a moving combustion chamber.
----------------------------------------
On third thought if I move the hole up so the trailing apex seal
just passes the hole before the plugs fire there will be no combustion
pressure leakage across the hole. I have done away with the solenoid
valve and replaced it with a synchronized piston air compressor.
The piston is phased such that the
injected fresh air reaches max velocity and pressure just before the
trailing apex seal passes over the air injection hole. The piston
compressor is geared to the e-shaft of course. Here is a 3D.
The one way side ball valve is the fresh air intake valve.
The other one way ball valve prevents the piston from
sucking in fuel/air mixture from the main intake chamber.
In a way this has a slight supercharge effect.
The question remains. Will the compressor suck more HP than
it will improve the BSFC?
--------------------------------------
I made some improvements. I moved the compressor to the inner
surface of the combustion chamber to increase the compression
ratio of the compressor and reduce the time for the air puffer
to work. There are three air squirting passages but not limited
to three. The dual intake valves are now in the head of the
compressor piston. They are ball valves that work
on inertia alone. Much like the Gnome Rhone Monosupape
of World War One. (Not strictly true but the word "Monosupape" is
a fun word to annunciate :)). Fresh air enters the crankcase of the
compressor an then up through the piston head. 3D-3 shows
the piston at TDC. In actual use the piston would be past TDC
at this TDC position of the rotor shown in the 3D.
BTW Mazda ought to love all these tiny parts that work like Swiss watches.
Very much in the tradition of the Mazda rotary engine. Still a very
simple and cheap stratified charge system compared to high pressure
direct injection of fuel. It also has a very benign failure mode.
Also BTW the reciprocating air compressor could be replaced by a very small
Wankel rotary type air compressor if one objects to the reciprocation.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.