> Mark's fuel injection system.
>
> I got the 3/8th Teflon I am waiting for the 3/8 spacer from Tom.
>
> Paul Lamar

That's a lot of butt splices.

I started with Mark's generous wiring harness :) It works.
It would be nice if we could get connectors for fuel injectors and coils
where the wire was not already potted into the connector. In other
words, connector shells and bare connector pins.

Paul Lamar

I have those for the LS-1 (D-580 version) coils and injectors with the
alignment tab in the center.  http://www.roblinphoto.com/shop/

Bob W.

Here is some additional information on the LS-1 coils that was recently
published on  one of the  other lists:
Here are the GM p/n's:
12558948 D-580 igniter  (primary and secondary on same end)
12558693 D-581 igniter  (primary and secondary on opposite ends,
connector different from D-580)
12563288 Bracket as used on Corvette to hold 4 D-580's  (can someone
verify that the D-581's will fit?)

I like the D-581 better because it gets the primary wiring away from the
high tension wires.

Bob, it was stated on the other list that you are looking for a source
for the D-581 connectors.  Have you found them?

You can't beat Bob's prices or the convenience!
Aubrey