>
>> > Mark's fuel injection system.
>> >
>> > I got the 3/8th Teflon I am waiting for the 3/8 spacer from Tom.
>> >
>> > Paul Lamar
>>
>> That's a lot of butt splices.
>>
>> I started with Mark's generous wiring harness :) It works.
>> It would be nice if we could get connectors for fuel injectors and coils
>> where the wire was not already potted into the connector. In other
>> words, connector shells and bare connector pins.
>>
>> Paul Lamar
>>
>
> I have those for the LS-1 (D-580 version) coils and injectors with the
> alignment tab in the center.  http://www.roblinphoto.com/shop/
>
> Bob W.
>
Here is some additional information on the LS-1 coils that was recently
published on  one of the  other lists:
Here are the GM p/n's:
12558948 D-580 igniter  (primary and secondary on same end)
12558693 D-581 igniter  (primary and secondary on opposite ends,
connector different from D-580)
12563288 Bracket as used on Corvette to hold 4 D-580's  (can someone
verify that the D-581's will fit?)

I like the D-581 better because it gets the primary wiring away from the
high tension wires.

Bob, it was stated on the other list that you are looking for a source
for the D-581 connectors.  Have you found them?

You can't beat Bob's prices or the convenience!
Aubrey

The only thing I've found was Delco p/n PT1627 (GM p/n 88987184) which
is probably a pigtail connector for the D581 coil.  I haven't even found
a picture of this p/n and have no way of confirming it is the correct
one.  They cost more than the coil.  Absolutely ridiculous.

Bob W.