Paul,
I seem to recall you posted a pic of an Eaton blower on a 13B Canard a
few months ago. I cannot find the post and am trying to design a bracket
for a Eaton M62 for my Renesis. Any chance you still have it around?
Thanks,
Bobby
OK that was Tom Jordan.
Paul Lamar
Given the reliability issues relative to turbochargers and the high EGTs
of rotary engines, would a blower be a better option for a 20B going on
a Skybolt? (aerobatic biplane)
Jim Kidd, Mequon WI
Given that cruise fuel consumption is not an issue with a aerobatic
airplane a super charger is not a bad way to go. It will be one powerful
aerobatic engine. What are you going to use for a gear box?
The gear box catches hell on an aerobatic air plane.
Paul Lamar
Frankly, I had not considered the PSRU as a potential weak link, as long
as it was capable of handling the horsepower. What do you see as the
issue? power, G, gyroscopic forces, structural integrity of the bolt-up?
I do not have a PSRU yet.
I thought I had the problems pretty well licked once I came across the
Powersport dry sump system for all attitude lubrication.
Jim Kidd, Mequon WI
Gyro forces on the prop shaft bearing and prop flange.
Also take a look at http://www.mistral-engines.com/
They have a PSRU that will handle a constant speed hydraulic prop which
is something else needed with aerobatic airplanes.
Paul Lamar
Actually, this depends largly on the type of acro you will be doing.
The CS prop is really nice but not entirely necessary. Alot of the
older Pitts specials have fixed pitch and most of the older Decathlons.
You can get away without one, but I definitely prefer one. Otherwise you
will need to keep a close eye on the throttle to make sure you dont overspeed.
As for the gyroscopic forces, you can reduce the wear and tear by avoiding snap type
manuevers which have extremely high gyroscopics. Of course they are alot of fun,
I'd give it alot of thought and plan accordingly. For the hardest acro, I'd go with
a very light composite CS prop, but that'll cost you alot. And as Paul pointed out you
will need a drive that would work with it.
John
Since the rotary tolerates overspeed better than a piston engine you
probably could go as high as 10,000 engine RPM (3500 prop RPM) from
time to time without hurting anything.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.