Paul,

Thanks for the info. I believe I have enough to design a chain drive to
fit the rotary now. Tentatively I plan a 7.5" offset and a 2.76 ratio.
I'm planning to use a stock Renesis as I have the room under the cowl to
fit the whole motor as long as the crank center is lower than the prop
center.

Soon as I finish my 3d of the fuselage I will start drawing the drive.
Anyone know how to transfer an Acad wireframe 3d into SolidWorks?

I'm sure I'll have some more questions at that time.

Thanks again
Ken

I am curious Ken. What kind of airplane is this going in?

Your target weight for the PSRU should be less than 35 pounds which
is what the Ross is. Let me know what you come up with.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.