Subject: Needed Junk 13B and oil pan
From: Rotary Engine
Date: 9/25/2005, 9:19 PM
To: AA-me




Or individual parts; rotor housings, end housings
front cover what have you.  We particular need a steel
13B oil pan. these parts are to be used in motor mount
mock up and final hardware. Will pay shipping.

Paul Lamar



Hi Paul,

Back from US trip but unfortunately was not able to fly the C-150 due to
discovery of many cracks in the landing gear bulkhead.  Should be finished
in a month or so.  Expensive annual this year.

If you can't find anything on the mainland I'll send you the block and oil
pan of an earlier 13B I disassembled.

Doug in Japan


Doug in Japan,

  If you haven't already, check to make sure you have the correct scissors
on your oleo. It is possible to get scissors that are too long, allowing the
nose wheel to hang a tad too low. A lot of pilots land very close to a three
point attitude, and a lot inadvertently apply a little left rudder during
their flare, putting the centre of the nose in front of them. This
combination can put a lot of side strain on the nose gear, over time causing
exactly the problems you have found. If the scissors are correct then make
sure you land straight, in a nice nose high attitude.

John




-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.