> I just stumbled across this planetary PSRU on
>
www.barnstormers.com, I case your looking.
>
> Erik
>
> By the way, I am NOT the seller.
>
> -------------------------------------------------------
> RD-1C 2.85 PSRU (LH ROT) • $2,500 • AVAILABLE FOR SALE
> • new, but never run. handles 400+hp, fits mazda 13B &
> 20B engines. lost med. send for pics • Contact Kevin
> Lane - located Portland, OR USA • Telephone: 503 233
> 1818 • Posted September 5, 2005
> -------------------------------------------------------
Tracy's site says the RD-1C is good to 300hp..
http://www.rotaryaviation.com/RD-1C.htm
Has that number been updated (upgraded) elsewhere?
Matt-
Should have no problem with that much HP. The Ford A4OD six pinion
gear set is used behind the Ford F250 Power Stroke V8 turbo diesel
with 600 foot pounds of torque. Max torque on a 3 rotor side intake
port engine is about 240 foot pounds. However that is assuming
you keep the oil cool.
BTW the torque out of the prop end in case anybody still thinks
airplanes fly on torque is 685 foot pounds.
HP = T x RPM / 5252 therefor HP x 5252 / RPM = input torque
400 HP at 8000 RPM would then be only 263 foot pounds input torque.
400 HP at 7000 RPM would be 300 foot pounds in case you are turbo charged.
I know you know this Matt. It is for some of our new subscribers.
Paul Lamar
Out of curiosity what kind of gear loads would be generated by 300 hp at
6,000 RPM? I'd be curious to know what bearing arrangement was selected
to handle the load.
Ken Bauman
300 HP x 5252 / 6000 RPM = 263 foot pounds.
What do you mean by bearing arrangement? Tracy uses a large ball bearing
for thrust on the outer end of the prop shaft and a small oil feed plain
bearing on the inner end of the prop shaft. To take the helical gear
thrust he is now using series of needle bearings instead of the roller
bearing.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.