Dear Paul,
Can't believe how informative your newsletter has been the last couple
of days since been included, thank you.
Paul, being new to Rotary engines and only now learning about them,
please give me your opinion on how the rotary and apex seal should be
lubricated. Should i leave the stock oil injector assembly as is or look
to change to a two stroke oil injector assembly.
When designing your own intake manifold, is there a specific or
minimum volumetric size for your plenum chamber, and what should
be your minimum length of your branches and diameter from plenum
chamber to manifold. The engine i am converting is the 13bt.
Regards,
Craig Todd
I would get rid of the metering pump and mix two cycle oil with the fuel.
The jury is still out on plenum size. Mazda has used rather tiny
plenums compared to what most people have built so far. It does not
seem to matter much.
Optimum length depends on the diameter and the PSRU ratio or
take off RPM. For 8000 RPM and a 2 inch OD tube with a .065 wall
the length is about 15 inches plus or minus one inch.
Slightly longer runners might improve the fuel burn slightly
at 6000 RPM cruise.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.