Subject: Bootstrap exhaust for Stratified Charge
From: Rotary Engine
Date: 9/27/2005, 9:57 PM
To: AA-me


> http://www.rotaryeng.net/Strat-charge.html
>
> Paul Lamar
>


Paul,

Would the combustion pressure be over the required 150 psi just before the
rotor uncovered the exhaust port?  If so, could a small amount of exhaust
gas be tapped at the synchronized time or some how else be used for the
"puff of air"?

Ideally, one would want the pressure of one chamber to provide the "puff"
for the following chamber and so on...

The "puff" could come from the opposite or other rotor/rotors on a
two/three
rotor set up if that would help the synchronization.

One way check valves and so on could complete the design with very low
cost.
If the exhaust gases are too hot, perhaps a heat exchanger could be used.
This may save power, weight, complexity and cost compared to the piston
recip or rotary compressor.

What do you think?

Norm DeBoer

Yes I thought about that. Since the rotors are 180 degrees out of phase
just a couple
of small cross over exhaust pipes might be all we need. The problem is
the pressure needs to be 150 psi or above because the compression phase
("stroke")  is almost done. Exhaust pressure is no where near that high.

Paul Lamar

Paul,

I think your original idea of the computer controlled solenoid valve has
much merit.  Your web site shows fresh air as the source of the working
fluid.  This could be accomplished with a computer controlled solenoid
valve, however the exhaust pressure could be ported to a large area piston
directly connected to a smaller area higher pressure piston. The exhaust
gases could also be used as the working fluid with a cross port like a two
stroke cycle piston engine.  The synchronization would be accomplished with
the computer controlled solenoid in between the high and low pressure
piston.  This could also double as the return mechanism to return the piston
back into position for the next pressure stroke.

Could this method reduce the power required to push out the unburned squish?

Norm DeBoer

Perhaps. Exhaust gas pressure is not much. 8 to 10 psi my guess.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.