Hi Paul,
I have been thinking, the length of runner from plenum to manifold, if
you are turbo charging the 13b, does the length matter that much and
what would be the draw back of a very short runner.
The reason why i ask is that the Ch801 kit has a recommended thrust line
of 200mm [7.8 inches] below the cowl. Space is limited above the engine.
Regards Craig.
I suspect the reason Mazda used long runners on all their turbo engines
is it gave them less fuel burn and more basic torque under conditions
of part throttle and medium RPM. The type of conditions an auto
engine is required to operate in 99% of the time.
For a turbo charged aircraft engine running at full boost WOT at 8000
feet and above it probably does not matter what the length of the intake
runners is. Makes sure you use an inter cooler.
Here is an idea that
reduces the pressure drop across an inter cooler system. It integrates
the inter cooler with the intake manifold and is now used by BMW
on the Mini. It could be used with much shorter runners. You would
have to move the turbocharger down stream on the exhaust system
which is probably beneficial to the health of the turbine.
Any time you reduce the intake pumping losses in an engine
you also reduce the fuel burn.
http://www.rotaryeng.net/outside-complete.jpg
How wide is the firewall? I'll see if I can knock out a quick
3D.
Paul Lamar
Good Evening In South Africa Paul,
Herewith a few basic dimensions of the Ch801 Lycoming cowl.
-The firewall is angled 18.5 degree from vertical.
-From top of firewall to front of prop flange is 985mm.
-Bottom of firewall to front of prop flange is 725mm.
-propeller flange is on center line while crank angled 2-3 degree to
left to allow for "P"factor
-crankshaft parallel to fuselage reference line, approximately 200mm [7.9"] to
top of firewall. Here they mention a tolerance of +/-5 degree.
-width of firewall is 920mm. [36.2"]
-depth of firewall is 818mm. [32.2"]
Thanking you Craig.
This is a rough layout done before I had your above dimensions.
I think it will fit. I'll do a bit more work on it later.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.