Jerry-


    The only thing keeping my engine where it belongs is a 2x4.  This

    worries me, since I share the hangar & my airplane gets moved around

    when I'm not there.  So, to answer your question, getting the rear mount

    was my #1 project.  I do have the local guy who could fab it for me --

    he's ready to whip it out for me quickly once given the right

    measurements but he doesn't weld, so I'll have to find a welder too.


Mark here is a photo of the prototype strut bracket.  Two things to
note:  one, the inside measurement is 1" which is also the outside
measurement of the rod end.  You may have to file the inside faces of
the bracket to get a smooth fit.  Secondly, the bracket is off set
toward the pilots side about an inch to clear the pan bolts so that  you
can get a wrench on them.  check to make sure it will still line up with
the firewall bracket.  If it will do the job, I will complete the
welding and send it to you.  You will have to enlarge the bolt holes
(Rod End) in the bracket.  Also, the bolt holes that attach to the pan
will have to be enlarged (presently drilled for 1/4 inch.)   I am not
set  up  yet to make the final version but it will be similar to what
you see here. Lastly, there is a lip on the pan that will have to ground
away in the area of the bracket.  I do have an extra Barry washer.   Jerry

P.S.  It is heavily constructed.  If you want to drill a few lightening
holes, go for it.


 Jerry


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.