Subject: SAE 2 Prop hub
From: Rotary Engine
Date: 9/28/2005, 11:52 PM
To: AA-me


Dear Paul,
Do you have a machine drawing of the exact dimensions of the SAE 2
prop hub.
Can you possibly explain graphically to me, how a hydraulic constant
speed propeller works and how it is controlled via rpm of motor.
Has the thought ever crossed your mind to possibly look at running the
propeller out put shaft on a PSRU between white metal bearings being oil
lubricated from engine.
Regards
Craig
SA

Is the number 2 the constant prop speed hub (small) or the wood prop
hub (big)? I can never keep them stright. I have an unofficial drawing
of the wood prop hub.

Paul Lamar


Paul,
The SAE #2 prop hub has a 4.75" diameter bolt circle.  For wood props
the lugs are 3/4" diameter with a 1/2" diameter bolt and the O.D. of the
hub is about 7.25".  For metal props the lugs are 5/8" diameter with a
3/8" bolt and the hub O.D. is as you have shown about 6.25".  The lugs
are either threaded, type "B", or unthreaded, type "A".   The centering
boss for both wood and metal props is as your drawing shows, 2.25" diameter.

Tracy's PSRU uses the smaller lugs and bolts.

BTW the difficult part of the constant speed prop is not getting the oil
to the prop hub, but mechanically driving the mechanical prop governor
from the PSRU.  Here is an idea to think about:  forget about the
mechanical governor and use a tachometer signal to control a pulse width
modulator circuit that controls a standard electro-hydraulic pressure
relief valve that controls the prop pitch.  We may need a small pump to
boost the pressure, but I think I would not be difficult to modify
Tracy's output shaft to provide engine oil through the shaft to the prop
hub.

Ed Anderson has done the preliminary design work for a digital prop
control with a very nice set of  features (stored set points, etc.).  A
PWM output could be added to this controller if we can work out the
details of the electro-hydraulic part of it.

Aubrey

www.legendaryaircraft.com
These guys make an adapter so you can drive the stock governor
with a cog belt drive off the front of the engine.

Paul Lamar

More pix of the adaptor. Ed told me he has sold 100's. Mostly
to aircraft engines without gov pads. He also says it takes
about 400 psi to change the prop pitch. Govs have oil pressure
boost pumps built in.

Paul Lamar


Paul,

The governor/pump is spinning all of the time maintaining 400psi in the
system? Hmmmm.  There goes a few horses. It probably has an internal bypass
valve in the pump  somewhere. I have been told hydraulics have the advantage
of rapid speed over electrics but I not sure what that means and if needed
in non acrobatic situations.

Correct me if I am wrong but with Butch's LAEV prop the motor uses juice
only when the position is changed right?  I am interested in the new
AeroComposites' C/S prop.  Pricey but light and extremely well made.  They
only make electric drives for their military contracts unfortunately. I
would have to modify  their hub to adapt a electric motor and worm drive
gear.

Doug in Japan

The big advantage to the metal CS prop is the high efficiency. I have
yet to see a composite prop equal it.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.