Subject: MegaSquirt & Rotary Engines
From: Rotary Engine
Date: 10/2/2005, 3:34 AM
To: AA-me


> http://www.megasquirt.info/
>
>  MegaSquirt & Rotary Engines
>
> This is an overview for using MegaSquirt on a
Mazda rotary engine. It > is not intended to be a primer on Wankel rotary
engines themselves, > only how to use MegaSquirt with them. To find out
more about Wankel > rotary engines, go to Blake Qualley's excellent
Rotary Engine > Illustrated web site. ....

Although this is ALL very good info, most of the
MS-EFI 'offical'
information on how to setup a rotary is from the
original 1.0 board and
MS SW.. things have changed and advanced
significantly since it was
written..

Ian
BAS

I am not so fond of the new one as the code is
written in C.
I got 20 years experience writing 6502/6800 asm.
I would rather enhance the code in asm myself.

BTW if people want to know what an EFI computer does
and when
it does it this is a flow chart. They are all pretty
much the
same. They all do only one instruction at a time.
A few abbreviations are called for:

RTC is request to send.
VE is Volumetric Efficiency.
EGO ????
PWM Pulse Width Modulation.
ADC analog to digital converter.
ASE ?????

IRQ is interrupt request. The computer monitors a
pin
and when it changes the computer stops what it is
doing
and does something related to the signal on that
pin.
When it finishes the IRQ task it goes back and
resumes
what it was doing before and where it left off.

SCI is a serial interface for communicating
with other hard ware over just a few wires.

What I really like about this is the openness of it.
You have the source code so you know when the
computer
does something and how it does it. If it does
something
you don't like you can change it.

Paul Lamar

EGO stands for "Exhaust Gas Oxygen", or the O2 sensor
voltage.

ASE stands for "After Start Enrichment", a scale
factor that enrichens the mixture post-start.  The ASE
decays rather quickly (max 255 seconds).  A second
scale factor, WUE, or "WarmUp Enrichment", is also
applied which decays with coolant temp.

Most all that info is still valid, although the latest
embedded code versions now use 12x12 tables, and have
native support for 2nd and 3rd gen ignition systems.
The ignition side of things is still in the beta test
stage, but looks to be pretty much debugged at this
point.  It is configured via a 12x12 advance table,
and an 8x8 split table.

Roger Enns.


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.