Subject: Seen at 7 stock 3 and 4 rotor engine shafts
From: Rotary Engine
Date: 10/8/2005, 6:49 PM
To: AA-me

Finally we have a US source for 2 and 4 rotor e-shafts.
http://www.autotechmotorsports.com/products.htm
In Chula Vista Calif. no less.

The thing about home made three and four rotor engines
is the use of the stock intermediate housings. These housing have
smaller ports than the end housing consequently the center
rotors are starved for air.

No problem if you p-port all the rotor housings.

Here is a pic of a turbo four rotor installed in a 3rd gen.
Looks like the stock 3rd gen throttle body and turbo plumbing.
As such it would be too small for this engine. In theory
with stock side porting this engine should generate around 560 HP.

With two large turbo charger and p-ports around 1600 HP.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.