Finally we have a US source for 2 and 4 rotor e-shafts.
http://www.autotechmotorsports.com/products.htm
In Chula Vista Calif. no less.
The thing about home made three and four rotor engines
is the use of the stock intermediate housings. These housing have
smaller ports than the end housing consequently the center
rotors are starved for air.
No problem if you p-port all the rotor housings.
Here is a pic of a turbo four rotor installed in a 3rd gen.
Looks like the stock 3rd gen throttle body and turbo plumbing.
As such it would be too small for this engine. In theory
with stock side porting this engine should generate around 560 HP.
With two large turbo charger and p-ports around 1600 HP.
Paul Lamar
Although I'm sure it's great to have a source of 3 & 4 rotor E-shafts..
the format is stupid.. ( strong word but..) Considering that mazda
has/is comming to the end of it's run on std.13B/BT housings and the 12A
housings have not been made new for YEARS.. making something like this
is far from fiscally sensable. Who's gooing to recycle 10+ year old 12A
housings onto a few $1000 shaft? throwing good money after bad In my
opinion.. maybe it's different down the south west USA, but up here in
Canada I don't have a source and my Mazda parts guy ( who I'm very good
friends with ) has no source for new or reman 12A rotors..
I find it very frustrating that allot of people still hold on to the
12A as a viable format..( mostly because it's an OEM carb format I'm
sure.. )
Ian
BAS
They must be available here in the states because I think
they are required for certain classes of road racing.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.