Subject: Le Mans Pport exhaust
From: Rotary Engine
Date: 10/12/2005, 5:58 PM
To: AA-me


Consensus for the exhaust tuning is two pipes around 32 inches.
Racing Beat has been selling headers like that for 30 years.

Paul Lamar

Does any one have a drawing or sketch of the 13B Exhast flange.  I'd like
to program
the part in the CNC Plasma and play around with Stainless Steel cutting.
Paul what
thichness of SS should I try?  T.W.

I would try 3/8" SS. I think the stock RB flange is 1/2" mild steel.
If you all really want to cut the weight go to the four bolt
flange.


Paul Lamar


TW
I have just had some SS flanges done and their a great fit. However the
water jet cutter tends to flair the cut edge and a plasma cutter would be a
bit rough, so I would tend to make the holes a little smaller and drill the
mounting holes to make them neater and recut ( just to neaten-up) the centre
hole on a four jaw chuck ( lathe).

I've made the centre hole to accommodate 2" OD pipe - a little larger than
recommended but can accommodate the turbo exhaust as well, if required

If you contact me on lendich@optusnet.com.au I can send you an AutoCAD 2004
drawing or something with sizes, if you don't have that facility.
George ( down under)

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.