I need to order a couple more of those p-port slide throttle sets
from you. Do you need a check in advance?
Paul Lamar
[ Todd Carrico ]
Are these for sale? I put in for two, and then stopped reading email
for a while. Sorry about that (hrm... make airplane parts, or read
email...)
I offered to buy two. What is the going rate, and how do I get hooked
up?
Send email to Tom
Tom Webber
<tWebber@cityofsacramento.org>
Paul Lamar
Hi all you P Porters out there in Rotary land,
I'm waiting to hear how well Rev11 Slide Throttle performs before we get carried away
and produce a lot of chips. When Mark and Mark get some info we can proceed on the
manufacture of the ST11 for all to purchase. Cost right now is aiming at $65.00. for
the pieces. I'm thinking I could go ahead and make the teflon also and put the
plates and slide together so the construction on the purchasers end will be the bends
and the ports all welding is on the purchaser.
Regards Tom Webber AKA T.W.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.