Subject: ST11 status (slide throttle part number)
From: Rotary Engine
Date: 10/12/2005, 3:38 PM
To: AA-me

I need to order a couple more of those p-port slide throttle sets
from you. Do you need a check in advance?

Paul Lamar


[ Todd Carrico ]
Are these for sale?  I put in for two, and then stopped reading email
for a while.  Sorry about that (hrm... make airplane parts, or read
email...)

I offered to buy two. What is the going rate, and how do I get hooked
up?

Send email to Tom
Tom Webber <tWebber@cityofsacramento.org>

Paul Lamar

Hi all you P Porters out there in Rotary land,
I'm waiting to hear how well Rev11 Slide Throttle performs before we get
carried away
and produce a lot of chips.  When Mark and Mark get some info we can proceed
on the
manufacture of the ST11 for all to purchase.  Cost right now is aiming at
$65.00. for
the pieces.  I'm thinking I could go ahead and make the teflon also and put
the
plates and slide together so the construction on the purchasers end will be
the bends
and the ports all welding is on the purchaser.
Regards Tom Webber AKA T.W.



This is Jim in Austin.  The new guy.  What is a "P" port.  Versus what other
kind of port?  Why would one want a "P" port?  Can I look this up on the
informative rotaryeng.net website?

Jim Beckman.
Austin

A P-port is a 2 inch diameter hole in the side of the rotor
housing. As such it breathes much, much better than the stock
side ports. A P-port 13B is easily capable of 300 HP while
the vast majority of side port engines are around 200 HP.

3 out of the seven rotary powered aircraft at OSH this year were
P-port engines.

See http://www.rotaryeng.net/intake.html

Click on the underlined topic lines.

Get back to me with further questions.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.