Paul,

After much thought I have 2 thoughts  for left side motor mount.#1 use
5/8 tube from upper firewall attach point (relocate expansion tank)down
to the horizontal rectangal that runs parallel to the engine. Add
another5/8 tube  from the lower left firewall attach point up to a
common point with upper tube.Leaving existing intake as is, this common
point would be about 6" from the existing 5/8 tube attach point at the
forward end of motor mount. This results in the 1"by 1.75"by 1/16 wall
rect.taking up the load between the two attach points.#2 move muffler
and use P-port intake to make more room for proper engine mount.?  In
your last reply I did not get a green line showing where to cut exist.
intake plenum.Thanks again for the help

Geir

OK Geir. Make a sketch of the firewall with dimensions
of the existing hard points and thrust line shown.
I'll draw in the existing motor mount and we will see what fits
where. Also the dia and length of the muffler. You might
as well keep most of it.

I'll do a 3D in about a week when I get back from the Tokyo
Motor Show.

Here is the jpg showing the green line.

Paul Lamar..... No rotor no motor!

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.