I've used these guys in the past, and would use them again in the future.

I don't have access to a machine shop, and would probably screw it up
if I did.
I made a drawing of a landing gear door bracket using the drawing software
supplied by them.

The Drawing software is by no means an "AutoCAD", but it does a good job.

CONCLUSION:

It may not be for people who do this kind of stuff for a living, but it
certainly
is worth looking into if you don't have access to a machine shop

Waiter


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.