Subject: New 20B parts
From: Rotary Engine
Date: 10/20/2005, 1:54 PM
To: AA-me


Since it appears one could purchase a complete new Mazda 2 rotary engine
here in the US from a dealer either in pieces or an assembled short or
long block, could one purchase the same components or assemblies for a 3
rotary from a dealer in Japan? If so, would you have to walk into the
dealership to make the purchase, or could it be done from abroad.

Jim Kidd

First there is no such animal as a 3 rotor side exhaust port
like the RX8 engine. The 3 rotor has been out of production
for at least ten years. All were peripheral exhaust port versions.
The RX8 will soon have a direct injection side exhaust port two rotor
16B engine with 100 mm instead of 80 mm rotor housings. The  RX8
Product Manager told me at the show it would be cheaper to make
than a 3 rotor with about the same power and be lighter weight
in the bargain. The other thing you get with wider rotor
housings is a better combustion chamber shape. Lower surface
area to volume ratio not to mention more torque.

You could build one using  an after market
3 rotor e-shaft from Guru racing in Australia. It would
be a bit down on power as the RX8 center housing would not be
a true 3 rotor center housing. Using a stock RX8 center
housing as the second center housing will result in
smaller intake ports on the center rotor. This problem will
go away if you make it a p-port 3 rotor with side exhaust ports.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.