Subject: Rough estimate of the 16B improved surface to volume ratio.
From: Rotary Engine
Date: 10/21/2005, 2:19 AM
To: AA-me

The current rotor is about 6.86 inches apex seal
to apex seal. The width is 80 mm or 3.15 inches wide.
The area of the combustion chamber not counting
the depth of the walls is therefore twice 6.86 X 3.15 or
about 43 square inches. Adding .2 inch high 4 square
inch walls the total area would be 47 square inches.

The volume assuming .2 inches average depth
would be  about 8.6 cubic inches.

Surface area to volume ratio would then be about 5.46.

The same numbers for the 100 mm wide 16B would be
58.45 square inches and a volume of 10.8

Surface area to volume ratio would then be about 5.41

What? When Vance Jaqua first told me this I did not believe
him. It was counter intuitive to my ex way of thinking.

OK round (piston engine): 8 inches in diameter A = 50.26
Volume = 10.052

S/V = 5 !!!!!!

All these years the Wankel rotary has been kicked around
by everybody and his brother because of the alleged
terrible "surface to volume" ratio. The first thing
I heard at the show out of the EDITOR-IN-CHIEF's mouth
was the alleged terrible "surface to volume" ratio :)

What really happens is the flame front tends to be circular so
it just fits better in a round or square combustion chamber
than in a rectangular combustion chamber. The wider rotor
16B is therefore  an improvement in this regard. The ideal rotor
would therefor be about 6.86 inches or 174 mm wide. The same
as one length of the rotor from apex seal to apex
seal.  That of course would result in a 5.6 liter 2 rotor
engine. Obviously the size of the rotor would have to
be reduced for the required smaller displacements of today's
automotive engine needs.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.