Hi Paul-

Got the entire intake side mounted today -- look *great*.

Problem:  The slide throttle doesn't slide when the bolts are torqued
down.  This is the same behavior I saw when we first got the slide
throttle from you; it wouldn't slide then either until I loosened the
bolts holding it together.  My hypothesis is that the Teflon insert is
a
bit too thick for the spacer.  I suppose I could try to take some
thickness off the Teflon. Or, I could fab a gasket of some type to
increase the thickness of the spacer.

Thoughts?

Mark

Did you put the gaskets in there? I sent some proper gasket
material. You may have thought it was packing material.
They needed to be cut out of the enclosed material.
One on each side of the spacer.

----------------------------------------

This is the stuff I sent Mark.
1/64" thick is .016 thick which should be plenty to space
the plates out far enough for the Teflon to slide.
http://www.mcmaster.com/

Search McMaster by the part number  9556K61 as there are a bunch
of gasketing materials.

Paul Lamar ...No rotor no motor.

Paul,
The image you sent with this message is corrupt on my end.

Russell Kent

Looked OK when I got it back. I also just loaded it into
xpaint and xv and both worked fine. It was a screen capture
so it was truncated at the bottom. Here it is again.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.