Subject: Lancair MM and cooling
From: Rotary Engine
Date: 10/25/2005, 9:54 PM
To: AA-me




This is a preliminary motor mount and one of several
possible cooling arrangements for a Lancair ES. Since
the Lancair ES has a fixed nose gear the under the
engine location for the rad may not be practical.
This is turbo so I will do a P-port version next.

Paul Lamar ...No rotor no motor.


Paul,
 From the tilt canopy, it appears that those pictures are of the Lancair
Legacy.  The mount, especially the nose gear location, looks very
similar to the ES mount though.  My ES came with a bed mount which has
an extra mounting point in the lower center.  I think you may need to
move the turbo as I don't think there is enough room where it is shown.

Mark S.


Thanks Mark. I assumed it was an ES because of the nose gear.
Here are a few more pictures in addition to your first one.

Paul Lamar ...No rotor no motor.

Paul, The Legacy has an attach hard point on the firewall for the center
point of the Continental bed mount as well.  It seems to me that it is a
little higher on the firewall than this pic of the ES.

Bill Bradburry


I am still awaiting the dimensions. These 3D's are just guesses at this
point. Everything will have to be adjusted. Does anybody have these
dimensions? I also need the position of the thrust line and
the lenght of the cowl from firewall to prop flange.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.