PAUL, Bill has indicated some doubt about the thrust line location so
we should not depend on it.  I am happy with it being on center
horizontally but the vertical position is not clear.  I guess it is
not indicated on the plans. It seems strange that such basic
information is not supplied by Lancair.   Jerry

<thrust line diagram for legacy.tif>

I just heard from Lancair on the thrust line.  Here is what they
said and
the tif file is attached.

Here is the Legacy thrust line diagram, and it is One degree down
and Two
degrees to the right. Please be careful what you put on the LML.

Justin Hawkins
Lancair Tech Support
541-923-2233

Bill,  I could not open the file.   I got a dialogue saying it was
corrupt. What is LML?
Paul,   I can create the engine off set by  pivoting the S-beam if
you can tell me how far,  measured from the Barry centers to the
firewall.  Can one degree down be achieved with the strut
adjustment?  Jerry



First thing is we need a file we can read :)
One lateral degree ain't much. One degree down is no problem.
Strut adjustment is fine for that.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.