Paul here is a drawing based on info from Bill.  I did not indicate
the thrust line and then accidentally tossed the file.  The thrust
line is on center and 5.375 inches below the upper mount centers.
Also, the gear leg center is 19.5 inches in front of the firewall.
(( Bill, please verify the accuracy of this drawing.))  The engine
sets forward of the nose gear leg.  If  you look at the photo I sent
of the Lycoming Dynofocal mount (Not the Continental bed mount) you
can see its position. The huge bay in front of the firewall is where
I would put the rad.    Jerry

OK that is a good start. I think I have the side view figured
out but what is the distance from the firewall to the prop flange?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.