Subject: Lanc Leg rear motor mount BV
From: Rotary Engine
Date: 10/28/2005, 8:13 PM
To: AA-me

The smaller rod ends on the ends of the tubes eliminate the need
for a third tube going someplace. They allow the rear mount
to move slightly back and fourth with the front rubber
bushings taking all the thrust load. They also allow adjustments
in the down thrust angle as the main rubber rod end is not
perfectly vertical. Side view shortly.
The smaller rods end can also be rubber from McMaster Carr.
The 3/8-24 male size ought to be about right.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.