Paul, I measured the longerons on the Legacy. They come out to 9.25" below
the top of the cowl or 1.125" below the top hard points.  The drawing shows
the thrust line to be 1.5" below the longeron line, then angles down 1
degree and to the right 2 degrees.

Bill Bradburry

Paul, I was incorrect when I indicated above that the drawing shows the
thrust line to be 1.5" below the longeron line.  Another  look at the
drawing shows it to be 2.5" instead.

Bill Bradburry


Bill please contact Lancair and ask them how far down from the upper
hard points the thrust line is. that will eliminate all ambiguitys.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.