I am going to add a mounting plate for the EC-2 disable switches to my
catalog (see link below).  For my installation, I had an extra 3 1/8"
mounting hole in the panel.  I think it used to be used for the fuel
flow meter.  So that's what I built the panel for.  There is also an
optional resistor tray that can be used with the panel, or bolted
elswhere to hold the 4 series resistors used with peak and hold
injectors.  There will have to be 5 inches of clearance behind the
panel for the resistor tray to fit there.

The panel with switches and as much wiring as I can do is $68.  The
resistor tray will be $18, and the 5 ohm 25 W resistors will be $3
each.  (You won't need the resistors if you have high impedence
injectors.)

I have attached a photo of the prototype.  It won't go into the catalog
until I have a picture of the final product, which may be a couple of
weeks.  If anyone is interested in one of these, send me an email at
sales@roblinphoto.com

Thanks,
Bob W.