Subject: Unsealed intake / exhaust ports?
From: Rotary Engine
Date: 10/31/2005, 10:05 AM
To: AA-me



Paul-

I was working on the prototype P-Port engine over the weekend & noted 2
ports that were not sealed (and came from Mazdatrix with tape over the
openings).  They are small, horizontally oriented oval shaped ports on
each end housing, right below the old side ports.

Are these in fact sealed up inside the engine?  What are they, and do I
need to do something about them?  Hopefully they are sealed internally &
the tape over the openings is unnecessary.  Otherwise, I shudder to
think of trying to seal them now w/o tearing down the whole engine to
make sure no sealant gets into the rotor chamber...

Mark Supinski

Are they black inside. If so it is probably exhaust gas heating I think.
They may be sealed inside. I'll send this  email to John at
Mazdatrix and see what he says.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.