Here are some shots of the final igniter mountings on the S-Beam.  As

you can see, I arranged the igniters above the bottom of the S-Beam to

make plenty of room for ducting beneath.  I've grouped the igniters to

obviously match them front vs rear rotor.  I also plan on using boot

color to distinguish top vs bottom rotor -- the goal is to make it as

idiot proof as possible & I am an accomplished idiot...


How hard would it be to fabricate some custom spark plug wires of

exactly the right length?  Bearing in mind the funky connector for the

LS1 igniters...


Mark Supinski

Nice job Mark.  I had my custom wires made in a speed shop that had the
right MSD tool for putting on the ends.  I made length templates out of
welding rod. Mine were very short and the end result was perfect.  I
can't remember exactly which wires and ends we ordered but I will try to
dig that up.   Jerry

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.