Should be no problem there. The beam is about 3 inches wide

and the rubber bushing are 2 inch in dia. So too the large washer.

You might have to trim the side wall of the beam just a bit.

Or lengthen the cup.

Paul,  I am worried about the bottom of the cup hitting the cowl.    Jerry

Triming the side of the S beam for clearance won't hurt.
If you are worried about it weld on an .049 doubler in the
trimmed area. Also a little bulge in the cowl won't hurt.
Don't forget it is further back by 3 inches so the cowl
should be deeper in that area.

It is also function of how high your upper  firewall hard points are.
You might have to use the P51 side beam style to come in at less
of an angle with the top tube.

Mock up the side view motor mount and take a picture for me.

Paul Lamar ...No rotor no motor.

The chain of pain has finally got my attention. I think it was the
thought of moving the coils and then probably having new wires made
up.  I will not be installing the modified pan on this installation.
Maybe next one.  We will just keep the engine mount as is...:)  Jerry

-----------------------------------------

Now you have it :)

Never the less I see no problems other than the muffler.

I redid the Tailwind 3D and here it is. No problems with the cowl
as the cups are moved back 3 inches when the cowl is deeper.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.