Subject: Injector holder air horn castings
From: Rotary Engine
Date: 2/1/2006, 5:46 AM
To: AA-me


back to my original question the description of that turbine states a 6000 rpm output shaft sounds like the RD1C might work for that. But whats the point if you have to refuel by the time you taxi to the end of the runway?


B.T.W. what is the diameter of those injected air horns you made? I want to buy some from Jenvy but I need to give them the correct diameter and do I want 1 injector or 2 in each horn?
Tony



There were two sizes 1.4" ID and 1.60 ID. Wall is about .15" inch.

Only if you are building P-port do you need two injectors per air horn.
And then the injector holder air horn castings would be too small.

They only come with a boss for one 2nd gen injector.

I have a few left if some one needs them. $50 each. Plus $20 for shipping
all four or just one. Cash. No credit cards.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.