Subject: Turbine on e-bay - fuel cons
From: Rotary Engine
Date: 2/1/2006, 12:56 PM
To: AA-me




        make them
        smaller. .65 BSFC is typical for small expensive turbo prop
   engines.
        The problem is simple geometry. As you make the engine smaller tip
        clearance between the compressor and turbine blades and the
   housings
        becomes critical. Also only two or three stages are used for the
        compressor



Tip clearance to turbine disc area is one concerrm, but I think the
other issue of geometry on engines (in general) is surface area / volume
relationship.  Any increase in the surface area / volume ratio within
the hot section increases heat losses, which reduces the amount of
energy available to drive the turbine.  Big engines clearly have the
advantage here.

A sphere with a radius of 1 has a SA=12.566, and V=4.188, and SA/V=3
A sphere with a radius of 2 has a SA=50.265, and V=33.51, and SA/V=1.5
A sphere with a radius of 3 has a SA=113.1, and V=113.1, and SA/V=1 (!)


Matt-



Good point Matt. I over looked that. Perhaps the 16B will be better
than the 13B/RX8 motor :)

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.