Subject: Turbine on e-bay - fuel cons
From: Rotary Engine
Date: 2/1/2006, 1:41 PM
To: AA-me


 >From RR themselves...

http://www.rolls-royce.com/service/downloads/amc_m250.pdf

Shows that the lowest (best) BSFC numbers for the 250 series is 0.574
which is achieved by the C40B at takeoff power.  Rated at 715hp..
Interestingly (predictably), the BSFC numbers are worse at reduced power
settings - cruise power BSFC is 0.591.  Almost all of the light domestic
turbine choppers run some flavor of this engine.  The lower power
versions have significantly worse BSFC - as bad as 0.706, which is given
for the B15A rated at 317hp.

Gas turbine efficiency as always is about thermodynamics.  The number of
spools (stages), the overall size, and the pressure ratio are the
biggest factors (hugely dominant) in determining the thermodynamic
efficiency. The larger, less "leaky", and more spools it has, the better
the thermodynamics work out.  Single spool turbines like the T62 are
limited by the physics of the machine.

When turbines are applied to a particular airframe, they are often given
a rating which is less than the max torque/temp(ITT) available from that
engine.  When an operator claims to run the turbine at 100%, that is
likely 100% of the rating for that application.  The derated value means
that the engine will suffer the poorer BSFC numbers associated with that
power setting.


Regards,

Matt-


Good post Matt.

I can tell you from personal experience driving M1 tanks that the fuel
consumption is essentially constant whether idling or going full bore,
about a gallon a minute.  So to get the best MPG you go as fast as
possible.

Hans

And M1 tanks have heat regenerators :)

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.