BTW Ian where did you get the bell housing?
Paul Lamar ...No rotor no motor.
Dear Ian
What sizes do you need I have some sizes in stock and I can get
other
sizes of the constant tension. clamps techwelding@comcast.net
Regards
Ed Klepeis
Thanks Ed. I emailed the manufacturers, they gave me the name of an
agent
in Australia. I am having a spin muffler made for my Renesis, there is
room for a 6 inch can. I'll send a picture when its done.
A friend of Leon Prommet made it in Sydney. I can get you the details if
you like. Pic.
Thanks again
Ian, Down Under, Beadle.
----------------------------------------------------
What does it weigh Ian?
Looks heavy but a bunch of three or four inch diameter holes cut with
a hole saw ought to cut the weight and let the hot air out.
Do you have a picture of the starter side?
Clever idea of cutting a large hole in it and bolting on Tracy's
PSRU from the back side.
Paul Lamar
-----------------------------------------
Paul
Here are a couple more pictures. I don't know what it weighs but the hot air
should negate some of the weight.
Leon's comments on the original arrangement can't be repeated.
For anybody using the James cowling. The 13.5" UHS spinner will fit with a
bit of extra fiberglass (it's too flimsy anyway) and the 1/8" spacer from
Van's to clamp it on the other side of the crush plate.
Ian
---------------------------------------------------------
Thanks Ian. I can come up with a good guess based on the Aus
10 mm casting walls :) I met the bell housing guy when I was in Sydney.
Looks like a Toyota transmission adapter to 13B rotary.
BTW are you going to lock those APV valves in the open position?
"Leon's comments on the original arrangement can't be repeated."
Of course not. Not invented by him and I thought of it :)
Doug thought of mounting it from the inside without mods.
--------------------------------------------------------
-------- Original Message --------
Subject: Adapting Tracy's box to Mazda bell housing
Date: Mon, 28 Nov 2005 09:33:18 -0800
From: Rotary Engine
<rotaryeng@earthlink.net>
It might be possible to to adapt Tracy's box to a stock
Mazda auto tranny bell housing. No longer input shaft
required. Reduction section is partially inside the bell housing.
Also the prop flange will still be the standard 14 inches from the
engine end housing.
The idea here is to machine about 1/2 inch off the main casting
and sandwich the 1/2 inch adapter plate between Tracy's spacer and
the main casting. Will only work with the 2.85:1 box as the ring gear
is stationary and not the planet carrier. A new internal end cap must
be made for the sun gear thrust bearing and input shaft oil seal.
--------------------------------------------------------------------
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.