Can one of you Aussie mates please figure out the name of this
place in Sydney that manufacters and sells these
transmission adapters? As far as I can tell Google does
does not know about them. I have a biz card some place I think.
Jap Performance would probably know who they are if you
call them first.
http://www.japperformance.com/
JAP Performance (Sydney, Australia)
Phone     +612 9601 6715
Fax     +612 9821 4525    
6 Kelso Crescent,
Moorebank,
New South Wales,
Australia.    
Paul Lamar ...No rotor no motor.

We've discussed the Rotary Marine housing in the past.  It weighs 7 lb
and cost a little over $300.  It looks like you could bolt a cut-down
version of Tracy's mounting plate to it.  Is this an option?

Scott Gettings


I think you would have to split Tracy's case and do something like
this. Either that or use two plates. Getting heavier.

I am confused about the advantage of using a bell housing, are you
trying to add length?

Hans

Just cosmetics Hans. Tracy's stock set up looks home made.

With the new bell house scheme lenght can be almost anything you want
it to be but to use Tracy's moving parts (shafts) it needs to be about
14.5 inches from back of engine to prop flange.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.