Subject: Proposed oil cooler location?
From: Rotary Engine
Date: 2/4/2006, 6:25 PM
To: AA-me



Paul-

The idea of a 13"x 13"x2" oil cooler is a non-starter.  After messing
around with the radiator, there is no way a square oil cooler is going
to fit anywhere.

After playing with a variety of locations, I came upon this idea:

http://supinski.net:8080/IMG_2424.JPG ,
http://supinski.net:8080/IMG_2425.JPG

This mocked-up core would be 7" x 19" and 2 1/2" thick.  Obviously it
could be the common 3" thickness instead.  Since this cooler is fed by
the oil pump, is there any risk of the air high-point at the top causing
problems?  My guess is no - the core will fill from the bottom at pump
pressure & drive out the air as it goes.  I wonder if the pump can raise
an oil column that high?

I like this design because it makes plumbing the air diffuser easy
enough; can bring air in a straight shot from the starboard cheek.  It
also doesn't block access to the plugs & igniters (much).  My plan would
be to allow air to pass through the cooler & then make it's way out of
the cowling with no additional ducting.  In my mind the warmed air blows
on the batteries & helps keep them at a reasonable temp before finally
exiting at the bottom of the cowl behind the radiator.

Finally - it lets me use the mounting bolts already on the end housing
of the engine to solidly secure the cooler.

Reasons why this won't work?

Mark Supinski

This will work fine with the right ducting. Brackets are the least
of your worries.
The pump will have no problem. Where did you find a 7" by 19" cooler?
A stock 2nd gen cooler would fit fine along side the rad.

A 13 by 13 would fit at about a 45 degree angle (about 9 inches wide
in that case) where you have this one or a bit further forward to clear
the motor mount tube. Or forward  laid back at a 45 degree angle to
clear the motor mount tube. There are lots of options because your
firewall is so high and the alt fits on top of the engine freeing
up a lot of space on the right side.

Your installation is looking real good Mark.
Don't forget the jam nuts on the rear motor mount strut.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.